Led Neon Flex 9.6w 4000k 15 Metres IP67 TOP BEND 10mm Wide
In stock
Catalogue Number
24VIP67NF10NW15
£312.50
Delivery Time: Next day delivery if ordered before 1.30pm
TOP bending Led Neon Flex in 15 metre packs including end cap each end
24 volt Dc . Requires a 24v Driver .
IP67 waterproof rating
4000k white CRI90 .
Cuttable every 3.5cm .
Mounting clips and spare end caps available
9.6 watts per metre and Dimmable
10mm wide 10mm high
3 year warranty
940 lumens per metre
Supplied with a 150mm input lead at both ends
Made to measure sizes can also be ordered by phone or email
Volt drop will occur after 7.5m unless the tape is powered up at both ends meaning a maximum of 15metres can be reached when using this method.
An aluminium profile buckle is available in related products to make installation easier
24 volt Dc . Requires a 24v Driver .
IP67 waterproof rating
4000k white CRI90 .
Cuttable every 3.5cm .
Mounting clips and spare end caps available
9.6 watts per metre and Dimmable
10mm wide 10mm high
3 year warranty
940 lumens per metre
Supplied with a 150mm input lead at both ends
Made to measure sizes can also be ordered by phone or email
Volt drop will occur after 7.5m unless the tape is powered up at both ends meaning a maximum of 15metres can be reached when using this method.
An aluminium profile buckle is available in related products to make installation easier
Led Neon Flex in 15 metre packs with a 150mm input on both ends . 24 volt Dc . Requires a 24 volt Driver . This Neon flex is TOP BENDING but will also side bend slightly (Approximately 45 degrees over 200mm . See images . On straight runs Aluminium profile 1413FR2 can be used if preferred to mounting clips .
Proper installation practices are essential when handling top bend neon flex lighting. By checking that the tape is always bent along the same plain ensures that the components within the lighting fixture are not damaged during shaping and installation. Overbending or folding these types of tape can result in damages to the product. Therefore, do not attempt to exceed to shape the tape past the natural diameter of the tape. Do not twist or bend the tape backwards on itself. Follow the natural curve of the top bend lighting tape and you should experience minimal issues when shaping it. An aluminium profile buckle is available in related products to make installation easier
Delivery Time | Next day delivery if ordered before 1.30pm |
---|---|
Manufacturer | T-Lighting |
Write Your Own Review