Smart Home RF and Bluetooth RGB Receiver for Pixel led strips

RF and bluetooth receiver for 12 and 24 volt Pixel led strip only .This device is connected between the led strip and the secondary side of the driver .The input is wired + and - but it also has a jack plug option to power it . It can operate from an RF remote or via Bluetooth on your android or iphone using the app "BanIan X" The app allows you to operate the receivers individually or group them so they can operate altogether. The remote allows you to operate on zones or altogether but the LED strips will not copy each other on modes on the remote. The app has dynamic modes/ Solid colour selection/ Music modes with the choice of the tape listening to your music library, through your mobile/devices microphone or the built in microphone on the receiver. It also has a DIY section where you can create your own sequence for the tape. To sync the LED strips onto different zones on the remote you must do the following. For example tape 1 - Turn on - within 10 seconds press and hold the zone button you want the tape to sync to. The tape will flash 2-3 times. Then turn that tape off. Go to your next tape. Tape 2- turn on. repeat above but onto the next zone. Once that's completed you can turn back on your other zones and they will all be separate from one another. Then use the All button on the remote to operate altogether.